LS-Navigator2
07/17/2013
1.2.0.0
View the first line in the "Version Information" dialog,
which is displayed in [Version Information] under the [Help] menu.
If the following version number is displayed,
the update is not required.
LS-Navigator2 Version 1.2.0.0
Copyright (C) 2012 KEYENCE CORPORATION.
All rights reserved.
A PC with an older version of LS-Navigator2 installed on it
Make sure to confirm the version information for LS-Navigator2 before updating. This update file only functions to update an older version of LS-Navigator2 that has already been installed. Please do not discard the Master Disk that you have purchased, as a new installation cannot be performed using an update file only.
In addition, the Manual folder found in the folder where LS-Navigator2 has been installed will not be updated.
1.Download the update file.
This can be downloaded using the following procedures:
(1)Create a new folder on your hard disk.
(2)From the selection, follow the instructions given on the screen to download the update file.
Once a message asking you to run or save this file has been displayed, select save, indicate the folder that was created in step (1) and then click the Save button.
2.Perform the update.
(1)Unzip the downloaded file named "LS-Navigator2_Update_forLS-9000_ver1_2_0_0.zip".
(2)After unzipping the file, run "setup.exe" inside the resulting folder.
Perform installation according to the given instructions.
(3)Installation is complete once it shows that the InstallShield Wizard is complete.
(4)Launch LS-Navigator2 and check the first line inside the "Version Information" dialog that is displayed in "Version Information" under the [Help] menu. The update has been properly completed if the version number given below is displayed.
LS-Navigator2 Version 1.2.0.0
Copyright (C) 2012
KEYENCE CORPORATION.
All rights reserved.
[Version 1.2.0.0]: 07/17/2013
Supports EtherNet/IP® communication unit (CB-EP100) and PROFINET communication unit (CB-PN100) compatible controllers (version 3.01.00)
[Version 1.1.0.0]: 04/15/2013
Supports BCD unit (CB-BD100) compatible controllers (version 2.00.00)